Related Manuals for REMKO SLE 20
Summary of Contents for REMKO SLE 20
- Page 1 REMKO SLE 20 Swimming pool dehumidifier Operation · Technology · Spare parts Edition GB – T03...
-
Page 3: Table Of Contents
Troubleshooting Electrical wiring diagram Refrigeration circuit Diagram of condensate container Spare parts list for condensate container Diagram of unit SLE 20 Spare parts list SLE 20 Intended use Customer service and warranty Environmental protection and recycling EC declaration of conformity... -
Page 4: Dehumidification
REMKO SLE 20 Dehumidification The interrelated processes In terms of energy consumption, occurring during dehumidification dehumidification has one decisive are based on physical laws. advantage: These are illustrated here in simplified form in order to explain Energy expenditure is restricted the principle of dehumidification. - Page 5 ■ can absorb substantial amounts water vapour continuously contained in the air remains the of water, e.g. bricks 90-190 l/ circulates through the REMKO same and the relative humidity m³, heavy concrete 140-190 l/m³, dehumidifier. It is dehumidified increases. lime-sand bricks 180-270 l/m³.
-
Page 6: Safety Notices
REMKO SLE 20 Heat of condensation The energy transferred from the Vice versa, energy is released In drying processes, the heat ener- condenser to the air is composed during the liquefaction of gy is recirculated, which is consu- gas, which is called heat of med during evaporation and relea- condensation. -
Page 7: Description Of The Unit
The units are also used for the a delay of about 45 seconds. dehumidification of: Private swimming pools ■ Functional diagram of SLE 20 dehumidifier Wellness areas ■ Heated and Heated and dehumidified air dehumidified air Whirlpool areas ■... -
Page 8: Installation
REMKO SLE 20 Installation For optimal and reliable unit Electrical connection Condensate drain operation, the following information must be observed in The units are The condensate drain is located at ■ any event: operated with the bottom of the unit. -
Page 9: Commissioning
Commissioning Additional condensate Mounting the condensate Prior to each commissioning or container container depending on the local conditions, the air inlet and outlet grilles must Where it is not possible or difficult Mount the unit on the supplied be checked for clogging. ■... -
Page 10: Decommissioning
REMKO SLE 20 Care and maintenance Status display LED Cleaning the suction filter NOTE Regular care and maintenance The LED on the front panel lights The suction filter should be is a basic precondition for a checked at regular intervals and... -
Page 11: Troubleshooting
Troubleshooting The units were manufactured using Unit switches off The red pilot light (fault) the latest production methods automatically – restarts after lights up also when the and tested repeatedly for perfect 45 minutes and switches off condensate container is function. -
Page 12: Electrical Wiring Diagram
REMKO SLE 20 Electrical wiring diagram Electronic control board Legend: M1 = Compressor M2 = Fan TS1 = Condenser sensor TS2 = Evaporator sensor Y1 = Solenoid valve Refrigeration circuit Legend: 1. Compressor 2. Evaporator 3. Condenser 4. Capillary tube 5. -
Page 13: Diagram Of Condensate Container
Condensate container (accessories) Additional condensate container Where it is not possible or difficult to provide a natural condensate drain, the unit can be provided with an additional condensate container. The condensate container is mounted directly below the unit. When the unit is used with condensate container, the dehumidifier automatically switches off when the container is... -
Page 14: Diagram Of Unit Sle 20
REMKO SLE 20 Diagram of unit SLE 20 We reserve the right to make changes to dimensions and the design in the interest of technical advances. -
Page 15: Spare Parts List Sle
Spare parts list Designation EDP No. Wall bracket 1109100 Housing, complete 1109101 Compressor, complete 1109102 Starting relay, complete 1109103 Operating switch 1109113 Fan motor 1109105 Fan blade 1109106 Control board 1109107 Diode board 1109108 Electronics cover 1109109 Solenoid valve, complete 1109110 Condenser NTC sensor 1109111... -
Page 16: Intended Use
Important information on forbidden without the prior recyclable. recycling written permission of REMKO GmbH & Co. KG . The units are operated with Make your contribution towards environmentally-friendly and environmental protection by ozone neutral refrigerant R134A. -
Page 17: Ec Declaration Of Conformity
This declaration will be invalidated if the unit is used, installed or maintained improperly, or if modifications are made to the supplied unit without our prior permission. Name of manufacturer REMKO GmbH & Co. KG Klima- und Wärmetechnik Im Seelenkamp 12... -
Page 18: Maintenance Report
REMKO SLE 20 ✍ Maintenance report Unit type: ........Serial number: ........10 11 12 13 14 15 16 17 18 19 20 Unit cleaned – outside – Unit cleaned – inside – Condenser cleaned Evaporator cleaned Fan function checked... -
Page 19: Technical Data
1) Noise measurement DIN 45635 - 13 - Category 3 Unit dimensions SLE 20 Standard SLE 20 with condensate container All dimensions in mm We reserve the right to make changes to dimensions and the design in the interest of technical advances. - Page 20 REMKO, a partner who helps solve problems. Sales REMKO not only has an extensive sales network in Germany and abroad, but also unusually highly qualified sales experts. REMKO field representatives are more than...
Need help?
Do you have a question about the SLE 20 and is the answer not in the manual?
Questions and answers