General Operation; Hardware Setup - Kanguru KCLONE-4NVME User Manual

2. GENERAL OPERATION

2.1 Hardware Setup

1. Place the KanguruClone where there is proper ventilation. Avoid using the KanguruClone in
environments with high temperatures.
2. Make sure that sufficient power is supplied to the KanguruClone. Incorrect power will cause
faulty operation. It is highly recommended that you use a UPS (uninterruptible power supply)
with the KanguruClone.
3. You are now ready to begin using your KanguruClone. To begin, turn on the unit by flipping the
Power Switch located on the back panel.
Things to remember
• Make sure that sufficient power is supplied to the KanguruClone. Incorrect power will cause
faulty operation. It is highly recommended that you use a UPS (uninterruptible power supply)
with the KanguruClone.
• The KanguruClone is powered by an external power adapter that is controlled by a rocker
switch located at the rear of the duplicator.
• The KanguruClone supplies power to all drives during a session. There is no need to connect an
external power source to the drives.
Note: drives are not powered until you start a copy operation.
• It is OK to connect and disconnect Master or Target drives while the KanguruClone is powered
on. However, do NOT connect or disconnect drives while any operation is running or the drive
is being accessed. A green LED indicator blinking indicates that the duplicator is accessing the
drive.
• Connect all Master and Target drives securely before executing any Copy, Compare, Erase,
Load or Verify operation.
• All operation of the KanguruClone 4 NVMe is done through the touch-screen display. If you are
having issues with the touch input, try recalibrating the screen, or use a stylus to tap the screen.
6
General Operation