Hanseatic WQP12-J7735E User Manual page 67

(f)
4. Insert the two mounting brackets (f) into
the front slots on the top of the dish-
washer so that you can screw the dish-
washer to the worktop subsequently.
5. Remove the protective films from the
side end profiles (d).
6. Affix the end profiles to the left and right
edges of the dishwasher. This will pre-
vent a crack being visible between the
dishwasher and the adjacent kitchen
cupboards.
7. Push the dishwasher into the recess.
Installation, connection and commissioning
(25)
8. To position the dishwasher so that it is
level, the two front adjustable feet (25)
and the back adjustable foot of the appli-
ance can be adjusted by up to 50 mm.
– The front adjustable feet are equipped
with slots. Insert a screwdriver into one
of the slots and turn the adjustable feet
to the height required.
– You can adjust the height of the back
foot with the centre adjusting screw. Use
a Phillips-tip screwdriver for this.
9. Check the alignment with a spirit level.
10. Ensure that the dishwasher is level with
the upper edge of the worktop to prevent
it from tipping forward when you open
the dishwasher door.
(d)
11. Screw the dishwasher to the kitchen
unit.
Page EN-27
(f)
(j)
(e) (i)