Submenu Software Download; Submenu Set Factory Settings - RTS SIP-ISDN Hardware & Software Manual

Dual isdn audio codec. dual ip audio codec

Table of Contents

5.6.4

Submenu Software Download

The Firmware required for the RTS SIP-ISDN system is always included in the PC soft-

ware. Via the Software Download the firmware can be comfortably loaded on the sys-

tem.

Via the Browse button you select the firmware file. The file is always stored in the di-

rectory in which you installed the RTS SIP-ISDN application. The standard installation

directory is:

The name of the firmware file is „rts.ssw".

FIG. 43

Please press the Start button to load the firmware on your system. The Progress bar

shows the status of the download. After about three minutes the download will be fin-

ished. If the download had been successful, a message is displayed. After a confirmation

the system executes a reset.

NOTE

If a download had been faulty, you can simply switch off the unit and then switch it

on again. The new software is only written in the flash memory, if a download had

been successful. Otherwise the old firmware is maintained.

5.6.5

Via the submenu Factory Settings all settings are reset to the factory settings.

For safety reasons a confirmation is required.

C:\Programmes\RTS SIP-ISDN

SUBMENU SOFTWARE DOWNLOAD

Table of Contents