Step 4 - Install The Back Frame - Insignia NS-HF2005 Assembly Manual

STEP 4 - Install the back frame.

You'll need
6 Back frame (1)
1 Make sure that the smooth side of the back frame (6) is facing the front of your stand.
2 Align the holes on the back frame with the holes in the middle and lower frames (4 and 5) and the holes on the top of
the upper back crossbar (2).
CAUTION: Do not fully tighten the bolts until the end of step 6.
3 Insert four 6 × 35 × 10 mm Allen bolts (C) through the holes in the back frame and into the holes in the middle and
lower frames. Use the Allen wrench (E) to tighten the bolts. Do not fully tighten the bolts.
4 Insert two 6 × 41 × 10 mm flat head Allen bolts (D) through the holes on the top of the upper back crossbar and into
the holes on the back frame. Use the Allen wrench to tighten the bolts. Do not fully tighten the bolts.
8
C 6 × 35 × 10 mm Allen bolt
(4)
www.insigniaproducts.com
D 6 × 41 × 10 mm flat head
E Allen wrench (1)
Allen bolt (2)
66" Metal & Glass TV Stand