Step 3 - Install The Middle And Lower Shelf Frames - Insignia NS-HF2005 Assembly Manual

STEP 3 - Install the middle and lower shelf frames.

You'll need
CAUTION: Do not fully tighten the bolts until the end of step 6.
1 Make sure that the holes on the frames are facing up.
2 Align the holes in the middle frame (4) with the holes in the side frames, then insert two 6 × 28 × 16 mm Allen bolts (B)
through the holes on each end of the middle frame and into the side frames. Use the Allen wrench (E) to tighten the
bolts. Do not fully tighten the bolts.
Note: The middle frame (4) has holes near the center of the frame sides. The lower frame (5) has holes near the outer edges of the
frame.
3 Align the holes in the lower frame (5) with the holes in the side frames, then insert two 6 × 28 × 16 mm Allen bolts (B)
through the holes on each end of the lower frame and into the side frames. Use the Allen wrench (E) to tighten the
bolts. Do not fully tighten the bolts.
4 Middle frame (1)
B 6 × 28 × 16 mm Allen bolt
(8)
www.insigniaproducts.com
5 Lower frame (1)
E Allen wrench (1)
NS-HF2005
7