Bosch MUZ9CC1 Instruction Manual page 11

– Do not process frozen food.
– The length of the cubes can be influenced
by increasing or reducing the pressure on
the pusher when pushing down.
Recommended speeds
1 e.g. boiled potatoes, carrots
and eggs, cucumbers, bananas,
strawberries, melons
3 e.g. raw potatoes and carrots,
soft sausage (e.g. mortadella),
hard cheese, peppers, tomatoes,
onions, apples, kiwifruit
Caution!
– If these guidelines are not observed,
the dicer, including the cutting grid and
the rotating blade, may be damaged.
– If the dicer is not used as intended, is
modified or is used improperly, Robert
Bosch Hausgeräte GmbH cannot
assume liability for any resulting
damage. Also excluded is the liability
for damage (e.g. blunt or deformed
blades) which result from processing
unapproved food.
Preparation
W Risk of injury
– Do not grasp the sharp cutter disc or
cutting grid. Take hold of the cutter disc
and cutting grid only by the edge!
– Before attaching or removing
the accessory, wait until the drive
has come to a standstill and pull out
the mains plug.
– The accessory must be completely
assembled before use.
– Never assemble the accessory on the
base unit.
– The accessory should only be used in
the intended operating position.
Caution!
The dicer insert may only be used with the
MUZ9VL1 continuous-feed shredder.
X Image sequence B
1. Insert the cutting grid into the base
holder as shown. Observe the recesses.
2. Fit the cutter disc with the blade guard
onto the base holder.
3. Press in the 4 catches until they
engage.
4. Insert the disc holder in the housing.
Both wings must be at the bottom.
5. Fit the dicer insert onto the disc
holder (,).
6. Remove the blade guard.
7. Fit the lid (,).
8. Rotate the lid in a clockwise direction as
far as possible (;).
Use
W Risk of injury
Never reach into the feed chute. Only use
the pusher provided when adding food.
Caution!
– Prevent the cut ingredients from building
up in the outlet opening.
– Do not apply great force with the pusher.
Important: Only prepare the base unit as
described in the main operating instructions.
The continuous-feed shredder can only
be operated if the bowl is fitted properly
(without lid).
X Image sequence C
1. Position the prepared continuous-feed
shredder on the front yellow drive as
shown.
2. Press down and rotate in a clockwise
direction as far as possible.
3. Plug the mains plug into the mains. Turn
the rotary switch to the recommended
speed.
4. Add the prepared food to the feed chute.
5. Only use the pusher provided to add
food.
6. When you have finished processing or
when the processed food in the bowl
almost reaches the outlet opening,
turn the rotary switch to y. Wait
until the drive comes to a standstill.
Disconnect the mains plug.
Preparation en
11