Table of Contents
Advertisement
|
Recovering the boot block from the recovery
|
CompactFlash card
Read "Safety notices" on page v before you continue with
these instructions.
Perform these instructions using the thin client that
requires the new boot block:
1. Perform Steps 1 to 4 in "Removing the logic unit" on
page 33.
2. If a CompactFlash card is already installed, remove it
by carefully pulling out of the flash card slot. If a
CompactFlash card is not installed, go to step 3.
3. Carefully insert the recovery CompactFlash card into
the flash card slot.
For more information on CompactFlash cards, see
"Appendix C. CompactFlash card" on page 35.
4. Move the jumpers on headers A and B into
configuration 3 .
5. Reconnect the power cable to the logic unit.
6. Power on the thin client, and wait for the system
LED to flash green.
If the system LED flashes amber, the image was not
copied correctly. Replace the logic unit (see
"Appendix A. Replacing hardware parts" on
page 29).
7. Power off the thin client.
8. Remove the recovery CompactFlash card.
9. Move the jumpers back into the default configuration
1 .
10. If you removed an original CompactFlash card in
step 2, reinsert it into the flash card slot. If you did
not remove an original CompactFlash card in step 2,
go to step 11.
11. Perform "Reassembling the thin client" on page 34.
40
IBM NetVista N2200l Thin Client for Linux
Diagram 2
Advertisement
Table of Contents
