Advertisement
AUTOMATIC SAFETY VALVES
This safety device automatically closes the gas valve if the inconvenience caused by failure to
comply with this rule.
CLEANING AND MAINTENANCE
GENERAL
Cleaning and maintenance should be carried out with the appliance cold especially when
cleaning the enameled parts. Avoid leaving alkaline or acid substances (lemon juice, vinegar
etc.) on the surfaces. Avoid using acid or chlorine-based cleaning products.
To extend the life of the built-in gas hob, it is absolutely indispensable that it be cleaned
carefully and thoroughly on a frequent basis, keeping in mind the following:
ENAMELLED PARTS
All of the enameled parts must be washed only with a sponge and soapy water or with non-
abrasive products
BURNERS AND GRIDS
These parts can be removed and cleaned with appropriate products. After cleaning the
burners and their flame distributors must be well dried and correctly replaced. It is very
important to check that the burner flame distributor(8) and the burner cap(7) has been
correctly positioned ( fig. 2) -failure to do so can cause serious problems.
Check that the igniter(5) is always clean to ensure trouble-free sparking. Check that the
thermocouple(safety device 6) is always clean to ensure correct operation of the safety valves
(for models with safety device).
STAINLESS STEEL can be stained if it remains in contact with highly calcareous water or
aggressive detergents (containing phosphorous) for an extended period of time, it is
recommended that these parts be rinsed thoroughly with water and then dried well, It is also a
good idea to clean up any spills;
Both the safety device(6) and igniter(5) must be very carefully cleaned.
Table of recommended pans
Burner
Auxiliary
Semi rapid
Rapid
Triple ring
Ø Pan diameter in cm
from dia. 8 to dia. 14
from dia. 14 to dia. 20
from dia. 20 to dia. 28
Above dia. 26
3
Hide quick links:
Advertisement
