Do not climb on the monitor or the table where the monitor is installed. Do not install the monitor on a
wheeled table if the wheels on the table have not been properly locked. The monitor may fall causing
damage to the monitor or personal injury.
Do not touch LCD panel surface while transporting, mounting and setting. Applying pressure on the LCD
panel can cause serious damage.
If the monitor or glass breaks, do not come into contact with the liquid crystal that is inside the screen. If
the liquid crystal comes into contact with your eyes or mouth, rinse thoroughly and immediately contact
your doctor for help.
Handling the power cord.
Handle the power cord with care. Damaging the cord could lead to fire or electric shock.
When connecting the power cord to the monitor's AC IN terminal, make sure the connector is fully and
Do not connect or disconnect the power cord with wet hands.
When connecting or disconnecting the power cord, pull the power cord out by holding onto its plug.
When cleaning the monitor, for safety purposes unplug the power cord from the power outlet
beforehand. Regularly dust off the power cord by using a soft dry cloth.
Before moving the monitor, make sure the monitor power is off, then unplug the power cord from the
power outlet and check that all cables connecting the monitor to other devices are disconnected.
When you are not planning to use the monitor for an extended period of time, always unplug the
power cord from the power outlet.
To ensure the monitor's reliability, please clean the ventilation holes at the rear side of the cabinet at least
once a year to remove dirt and dust.
Handle with care during installation and adjustment to prevent personal injury and damage to the monitor.
The monitor must be mounted to a flexible arm or stand that supports the weight of the monitor to prevent
damage and personal injury that could result from the monitor tipping over or falling.
Please tighten all screws when installing the monitor to a flexible arm or stand. A loose screw may
cause the monitor to fall, causing damage to the monitor or personal injury.
Do not connect headphones to the monitor while you are wearing them. Depending on the volume level, it
may damage your ears and cause loss of hearing.
Please install the monitor in accordance with the following information.
Improper installation of the monitor may result in damage to the monitor, an electric shock or fire.
Allow adequate ventilation around the monitor, so that heat can properly dissipate.
Do not cover the vent on the monitor.
Clean the monitor's LCD screen surface with a lint-free, non-abrasive cloth.
Avoid using any cleaning solutions! DO NOT clean with benzene thinner, alkaline detergent, alcoholic
system detergent, glass cleaner, wax, polish cleaner, soap powder, or insecticide. Rubber or vinyl should
not be in contact with the cabinet for an extended period of time. These types of fluids and materials can
cause the paint to deteriorate, crack or peel.