Table of Contents
Advertisement
To connect the monitor to your system, follow these instructionsE:
OTEE:
Make sure to read
1. Turn off the power to your computer.
2. Place the monitor face down on a non-abrasive surface.
3. Connect devices to the monitor.
CAUTIOE:
Use the provided specified cables with this product so as not to interfere with radio and television
reception.
For DisplayPort and HDMI, please use a shielded signal cable.
Use of other cables and adapters may cause interference with radio and television reception.
CAUTIOE: •
OTEE: •
Adjustment of the volume control as well as the equalizer to other settings than the center position may
increase the ear-/headphones output voltage and therefore the sound pressure level.
•
Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor lowers the sound.
•
Incorrect cable connections may result in irregular operation, damage display quality/components of the LCD
module and/or shorten the module's life.
4. Connect the power cord to a power outlet.
OTEE: •
Please refer to the Caution section of this manual for proper selection of the AC power cord (see
•
Please make sure that enough power is supplied to the monitor. Please refer to
"Chapter 4 Specifications" on page
5. Turn on the monitor by pressing the
OTEE:
If you have any problems please refer to the Troubleshooting section of this User's Manual (see
"Recommended Use" on page 3
Power cord
Do not connect headphones to the monitor while you are wearing them. Depending on the volume
level, it may damage your ears and cause loss of hearing.
button and then turn on the computer.
before installation.
HDMI
DisplayPort
D-SUB
23.
English−14
Audio IN
Headphone
"Power Supply"
page
1).
in the
page
20).
Advertisement
Table of Contents
