System Configuration - Omron NT600M Series Operation Manual

System Configuration

(2) Display Functions
Function
Vertical and
horizontal
display
Bar Display width
graphs enlargement (2
to 255 dots)
+/– display
% value
enlargement
display
Lamp display:
Rectangular or circular
Lamps/touch switches:
Guide character mark
input
Touch switches: Solid or
rectangular frame
Numeric setting 10-key
layout
Numeric display
enlargement (64x max.)
Direct connection See note 3.
Notes 3. Some restrictions may apply, depending on the PT model.
1-6 System Configuration
10
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
NT20M-ZASAT NT600M-SMRjjj
Support Tool
-EV4 -EV1 -EV1
onwards
X
F F
X
F
X
F
SMR 31-E/32-E
4. In order to use the direct connection function, a Support Tool version of
"-EV4" or higher must be used.
In order to operate the NT600M, connect a personal computer or a Program-
mable Controller, to serve as a host, to the Host Interface Unit (sold sepa-
rately) at the back of the NT600M. For details on connecting the Host Inter-
face Unit, and on host programs, refer to the Host Interface Unit Operation
Manual .
The following interfaces can be used for communications: RS-232C,
RS-422A, Wired Remote I/O System (SYSMAC BUS), Host Link System
(SYSMAC WAY), or C200H Host Interface. A Screen Data Memory Board,
NT600M-MP/MRjjj, is also required and must be purchased separately.
PT Models
System ROM
-E
X All models
F F
DT-type only
X All models
F
(See note 1.)
X All models
F
DT-type only
Section 1-6
Remarks
X: Horizontal only.
X: Select either 8 or 16
dots.
X: + direction only.
X: Equivalent display
only.
X: Rectangular only.
X: Mark input not
possible.
X: Rectangular frame
only.
Only when the screen
attribute "10-key" is set to
"User."
X: Equivalent display
only.