Omron NT600M Series Operation Manual page 46

Transferring Data to and from the Support Tool
Abort:
! Caution
36
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
4. When the data transfer begins, the direction of transmission, the type of
data being transmitted, and the memory capacity are displayed on the
screen.
Transmit Mode
KB
5. When the data transfer has been completed, those items will no longer
be displayed.
Abort:
6. In the event of a disconnected cable or other disruption while the trans-
fer is in progress, the NT600M screen will go blank and a message tell-
ing you that transfer was not possible will be displayed at the Support
Tool. If the transfer is completed successfully, then at the end of the
transfer the NT600M screen will go blank and a message telling you that
the transfer has been completed will be displayed at the Support Tool.
7. To return from Transmit Mode to RUN Mode, press the Buzzer Key, Up
Key, and Down Key simultaneously.
After the transfer has been completed, be sure to return to RUN Mode by press-
ing the Buzzer Key, Up Key, and Down Key simultaneously. If the power is turned
off or if a reset is executed without having first returned to RUN Mode, the data
that has been transmitted will be corrupted. If that occurs, a message will be dis-
played on the screen to indicate that the data has been corrupted.
PT ––> Tool
Tool ––> PT
Screen Data
System Memory
Memory Tables
Mark Data
History Data
Number of bytes transferred (in kilobytes).
Press these three System Keys simulta-
neously to stop the transfer in progress.
Transmit Mode
Section 3-3
Shows direction
of data transfer.
Shows type of data.