Standalone Function - Omron NT600M Series Operation Manual

Standalone Function

5-3 Standalone Function
Example
Registered Screen
Production Target
Model no. NT600M-DT122
Number
produced
Items Registered to Screen by Support Tool
Standalone function setting
Touch switch or function key number
Screen number to be displayed when touch
switches or function keys are input
Example
Standalone function is set.
Touch switch number:
Screen to be displayed: No. 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2) When Touch Switches are Used:
When touch switches are used, the cursor moves from area to area accord-
ing to the layout of the screen. Thus, in the screen example shown above,
the Down Key would move the cursor from numeric setting 2 to numeric set-
ting 5. After that, the Down Key cannot move the cursor any further.
Pressing the Up Key would then move the cursor back to numeric setting 2,
and then continue to move it upward in order to numeric settings 1 and 3.
The Right Key would then have to be used to move the cursor to numeric
setting 4.
When a screen for which the standalone function has been set by the Support
Tool is displayed, the screen can be changed by means of touch switches and
function keys.
Screen 5
Touch switch
no. 1 display
area
2,500
No. 1
Screen No. 5
Production Conditions
Production target:
Number produced: 2,500
Number defective: 2
When touch switch no. 1 is input,
screen no. 5 is displayed.
Section 5-3
5,000
59