Omron NT600M Series Operation Manual page 35

Installing the NT600M PT in a Panel
24
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2. Insert the PT into the hole from the front of the panel.
3. Use the accessory metal fittings and tool to fasten the PT to the panel
surface. Do not use a screwdriver. A screwdriver may damage the fit-
tings or the PT.
After setting the PT in the panel, secure it as shown below.
(1)
(2)
Plastic
NT600M
(b)
(a)
NT600M
4. To remove the PT from the panel, use a flat-blade screwdriver.
6 panel installation fittings
NT600M
(1) First pass the plastic part of the fit-
Fitting
ting through slot (a).
(2) Next, put the hook of the fitting into
slot (b) and pull so that the leg
catches in the PT case.
Accessory tool
(3) Turn the screw with the tool that
comes with the PT, and secure
the PT to the panel. There are six
places to be secured. When you
are finished, rotate the tool in the
inverse direction and remove it
from the screw.
– Standard screwdriver
Section 2-4