Remote Access; Remote Access Through Dial-In - Abus AZWG10020 Installation And Operating Instructions Manual

Once a voice memo is recorded, the display shows "** MEMO WAITING **".
Record
The device is in standby mode, that is, the display shows the standby
screen.
Briefly press the red record button to record a memo. Speak clearly into the
device. The device shows how much time has already elapsed.
To stop recording, press the record button again briefly. The display now
shows "** MEMO WAITING **".
The device can be programmed so that when there is a waiting
memo, the backlight of the display flashes and a beep sounds (see
"Display Options").
Play
The display indicates a waiting memo (** MEMO WAITING**).
Press ENT to play back the memo.
Press ESC to cancel playback.
Press CLR to delete the memo.
After deletion, the display returns to standby mode.

13.4 Remote Access

This functionality enables remote control of the device using a telephone
connection. For example, you can remotely record messages, listen in on
the premises, or use the outputs to switch the lights.
13.4.1

Remote access through dial-in

With this option, you dial into the device remotely.
Note:
"Remote Access" must be turned ON. See "Menu Functions  System
Options  Remote Options".
Please pay attention to the information under System Options  Remote
Options  1 Ring Answer" if there are other devices on the analog tele-
phone line used by the device.
Dial-in with function "1 Ring Answer" OFF
Dial into the device by dialing the device's telephone number.
1.
Note: The device accepts the call after the set number of rings
(see "Rings to Answer"). You will hear several beeps.
2. Now enter your 4-digit remote access code (factory setting: 5678).
A confirmation signal sounds if the entered code is correct. You
are now in remote access mode. The options that are now possi-
ble are described later in the Functions section.
Dial-in with function "1 Ring Answer" ON
41 UK