Test Options; Test Messages - Abus AZWG10020 Installation And Operating Instructions Manual

01
Call Fail Name
01
GSM Signal
Low
GSM Sig. OK
Call PSTN
Call GSM

12.10 Test Options

You use the various tests to check the proper functioning of your device and
whether the settings made are correct.
12.10.1

Test Messages

In this menu item, you test messages (voice and text). The device transmits
the selected message to the selected contacts as voice or text.
Use the arrow keys to select the various alarm messages and restore mes-
sages.
Route Alarm H
To **********
By pressing the number keys (1–9 and 0), you can select the available
contacts (1–10).
Route Alarm H
To *2*4*6***0
Press ENT to start the test; press ESC to cancel the test at any time.
Now each step of the testing process is shown on the display.
Example of a test on the analog line:
Via PSTN
Contacts 2–10 analogously
The contact name is displayed as programmed.
"Name 01" is the factory setting.
Call to contact 1 failed
Contacts 2–10 analogously
The contact name is displayed as programmed.
"Name 01" is the factory setting.
The GSM signal has dropped below the preset value for
the low end of the GSM signal strength.
The GSM signal has again exceeded the preset value for
the low end of the GSM signal strength. The GSM signal is
present and is again in the normal range.
Call being made over the analog telephone line
Call being made over the GSM network
36 UK