Advertisement
Teaching in the transmission codes
Sender einlernen
In the "Programming the transmission codes"
mode you can transfer the codes of your
transmitter buttons (A/B/C/D) to the receiver.
Teaching a call transmitter
R
<
1,6 s
Teaching an acknowledgement transmitter
Q/S
>5
s
A/B/C/D → Call signal can be acknowledged
using the taught transmitter button
Caution!
Acknowledgement is only possible if
the acknowledge function is activated
(Jumper J2 Pos. 1+2)
Teaching a switching transmitter
Q/S
<5 s
Q/S
<1,6 s
B/D OFF → switch off call function,
LED I/O flashes green
A/C ON → switch on call function,
LED I/O continuously
illuminates green
Q/S
programming button Q/S
R
programming button R
Tx
transmitter button
2
Press button
Call transmitter: To transmit a care call.
R
Tx
<
1,6 s
Tx
Acknowledge transmitter: To acknowledge a care call received.
Q/S
Tx
<
1,6 s
A
C
Tx
B
D
A/B/
C/D
Switching transmitter: Activation or deactivation of the care function
Q/S
Tx
<1,6 s
A
Q/S
C
B
D
Tx
A/C
Each type of transmitter can only be taught-in to the RCL07 once!
If transmission code A or B has been taught-in to transmitters with 2-touch opera-
tion for example, buttons C and D cannot be used in this RCL07.
Display LED RCL07
<1,6 s
LED R flashes slowly
<1,6 s
LED R illuminates for
1)
approx. 4 s
1)
LED R quickly flashes for ap-
prox. 4 s
>5 s
LED Q/S flashes slowly
(1x|break|1x| ...)
<1,6 s
LED Q/S continuously
1)
illuminates
1)
>5 s
LED Q/S flashes slowly
(1x|break|1x| ...)
<1,6 s
LED Q/S flashes
(2x|break|2x| ...)
<1,6 s
LED Q/S continuously
1)
illuminates
LED Q/S quickly flashes for
1)
approx. 4 s
Remark
The receiver is in teaching mode for approx.
30 s. Teach the transmission code during this
period, after the period has expired, the receiver
changes to operation mode.
The transmission code is transmitted. The
operating mode set at the receiver is accepted
with the save procedure and is applicable for
the transmission code saved. Subsequently, the
receiver changes to operation mode.
All 32 memory spaces are allocated.
The receiver is in teaching mode for approx.
30 s. Teach the transmission code during this
period, after the period has expired, the receiver
changes to operation mode.
Press the transmitter button with which you
wish to acknowledge. The transmission code is
transmitted and the receiver changes to opera-
tion mode.
All 8 memory spaces are allocated.
The receiver is in teaching mode for approx. 30
s. Teach the transmission code during this pe-
riod, after the period has expired, the receiver
changes to operation mode.
Press the transmitter button A or C, the trans-
mission codes are transmitted (Code B and
D are automatically allocated). The receiver
changes to ready for operation.
All 8 memory spaces are allocated.
Advertisement
