Advertisement
Available languages
Available languages
operating the timer
1 Press the button once, the display will flash "00".
2 Press again to set the countdown time in 1 minute
intervals. Hold the button in until the required set time is
reached ie "05" = 5 minutes. Then release the button.
Note: The timer will only display seconds when the
countdown time is below 1 minute.
3 The display will flash for 5 seconds - during this period
the set time can be increased by holding the button in
again. After 5 seconds the display will stop flashing and
the countdown will begin.
4 To change the countdown time during operation, press
and hold the button in for 3 seconds. The display will
reset to "00" and a new time can be set.
5 When the countdown has finished the timer will "beep"
for 15 seconds. To stop the timer beeping, press the
button once.
6 The display will automatically turn off after 45 seconds
if not in use.
oil change light
G
The oil change light will come on after approx. 10 hours
of frying as a reminder to change the oil.
G
Remove the oil and clean the fryer see "care and
cleaning"
G
To reset the oil light, fill the bowl with oil and switch on.
Then press and hold the oil light button in for 2-3
seconds until the light goes out.
care and cleaning
G
Never start cleaning until the oil has cooled
down.
G
Always unplug and remove the electronic control unit
before cleaning.
G
Ensure everything's completely dry before
reassembling.
electronic control unit
G
Never put it in water.
G
Before removing the electronic control unit check that
the cord is released from the cord storage area at the
back of the fryer
G
Pull out. Wipe with a damp cloth and dry thoroughly.
lid
G
Remove and soak in hot soapy water for 20 minutes.
.
basket
G
After each use, remove and soak in hot soapy water for
20 minutes. Then use a stiff brush.
fryer body and bowl
G
Soak in hot soapy water for 20 minutes. Then use a
non-abrasive cleaner.
G
If you have a dishwasher everything - except the
electronic control unit - is dishwasher safe. Your
dishwasher may darken the inside of the lid but it will
still work perfectly. For baked on oil, we recommend
soaking the bowl prior to dishwashing.
service and customer care
G
If the cord is damaged it must, for safety reasons, be
replaced by Kenwood or an authorised Kenwood
repairer.
G
If you experience any problems with the
operation of the fryer, before calling for
assistance refer to the troubleshooting guide.
If you need help with:
G
using your fryer or
G
servicing or repairs
G
Contact the shop where you bought your fryer.
4
Advertisement
