Snom M10 KLE User Manual page 6

13 Do not overload wall outlets and extension cords
14 Unplug this product from the wall outlet and refer servicing to an authorized
service facility under the following conditions:
A When the power supply cord or plug is damaged or frayed
B If liquid has been spilled onto the product
C If the product has been exposed to rain or water
D If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the
operation instructions. Improper adjustment of other controls may
result in damage and often requires extensive work by an authorized
technician to restore the product to normal operation
E If the product has been dropped and the telephone base and/or
handset has been damaged
F If the product exhibits a distinct change in performance
15 Avoid using a telephone (other than cordless) during an electrical storm
There is a remote risk of electric shock from lightning
16 Do not use the telephone to report a gas leak in the vicinity of the leak Under
certain circumstances, a spark may be created when the adapter is plugged
into the power outlet, or when the handset is replaced in its cradle This is a
common event associated with the closing of any electrical circuit The user
should not plug the phone into a power outlet, and should not put a charged
handset into the cradle, if the phone is located in an environment containing
concentrations of flammable or flame-supporting gases, unless there is
adequate ventilation. A spark in such an environment could create a fire or
explosion Such environments might include: medical use of oxygen without
adequate ventilation; industrial gases (cleaning solvents; gasoline vapors;
etc); a leak of natural gas; etc
17 Only put the handset of your telephone next to your ear when it is in normal
talk mode
18 The power adapters are intended to be correctly oriented in a vertical or floor
mount position The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet
19 Use only the power cord indicated in this manual
20 For pluggable equipment, the socket-outlet shall be installed near the
equipment and shall be easily accessible
21 In wall mounting position, make sure to mount the telephone base on the wall
by aligning the eyelets with the mounting studs of the wall plate Then slide
the telephone base down on both mounting studs until it locks into place
Refer to the full installation instructions in "Handset Installation" on page
15 in this User Manual
22 CAUTION: Keep small metallic objects such as pins and staples away from
the handset receiver
6