Table of Contents
Advertisement
DTH7500_en
4/07/03
For your safety
Never open the DMR or any of its components. It can be dangerous for you or for certain fragile
components.You could receive an electric shock or touch the laser beam. Do not place your eyes
close to the opening of the disc tray or any other opening to look inside the DMR.
DVD copy protection
In accordance with the DVD standard, your DMR is equipped with a Copy Protection system,
which can be triggered on and off by the DVD disc itself, in order to make any recording of the
concerned DVD disc onto a videotape of very poor picture quality, or even impossible. "This
product incorporates copyright protection technology that is protected by method claims of
certain U.S. patents and other intellectual property rights owned by Macrovision Corporation
and other rights owners. Use of this copyright protection technology must be authorized by
Macrovision Corporation, and is intended for home use only unless otherwise authorized by
Macrovision Corporation. Reverse engineering or disassembly is prohibited." If the appliance is
opened or its components interfered with (dismantled, replaced etc) the warranty clauses shall be
annulled.
Remote control - Code A-B
Remote control setting on code B
No. to key in
3000
Code A
3001
Code B
1.
Press and hold the
2.
With the number keys, press
3.
Release the
DMR setting on code B
1.
Switch on your DMR.
2. Check that there is no disc in the disc tray.
3.
Simultaneously press the
when your DMR displays
4.
Try to control your DMR with the remote control.
Note: in the event of a problem, redo the setting of both components:
the remote control and your DMR.
Technical data
Power requirements 220 to 240 V - 50/60 Hz
Power consumption 36 W when ON (approx.) < 3 W in the eco mode.
Functioning conditions +5°C to + 35°C surrounding humidity: 80 % maximum
Playback system Laser diodes - Wave length: 655 / 780 nm, Laser power CLASSE 2
Reception norms LL' - BG - I - DKK'
Number of storable channels 99
Remote control Infrared 33 Khz - Batteries 2 x 1.5 V (AAA)
Nominal Specification - THOMSON reserves the right to change the specifications without notice.
16:56
Page 57
On display panel
Note: the remote control of your DMR is set to code A (3000).
DVD A
To set it to code B (3001) follow the procedure described below.
DVD B
DVD
key.
3
,
0
,
0
,
1
.
key.
DVD
,
PAUSE
PLAY
DVD B
.
Further information
,
keys at the front of your DMR and release them
AV
57
EN
EN
DMR EN / RST - BEI / 07-2003
Advertisement
Table of Contents
