Connecting To A Monitor; Connecting To Power - Genie DN83SPX/12 Instruction Manual

■ Installation
When using a CS-Mount lens
Take off the lens protection cap and attach
the CS-Mount lens to the camera by screwing
it in clockwise.
When using a C-Mount lens
1. Take off the lens protection cap and
attach the C-mount adaptor.
2. Attach the C-Mount lens to the
camera by screwing it in clockwise.
Note
ㆍUse the specified lens connection parts as shown in the picture below.
The use of the wrong sized parts may cause damage
to the inside of the camera or result in poor fitting.
ㆍUse of a lens which is too heavy affects the balance
of the camera and may cause a malfunction. Please
use a lens that weighs less than 450g.
ㆍSelect Av mode if possible when adjusting the
automatic light control (ALC) of an auto lens.
Use of PK mode may cause hunting.
PIXIM Digital Day/Night Bodied Camera
14

■ Connecting to a monitor

Connect the video output terminal located on the back of the camera to
the monitor.
OSD EXTRA
IRIS JACK
VIDEO OUT
POWER
DC
SET
AC 24V IN VIDEO
DC12V IN
CMOS Camera
ㆍThe connection method varies depending on the type of monitor and
accessories. Please refer to the user's manual for each instrument.
ㆍTurn off the power when connecting.

■ Connecting to power

Check the standard power requirement before connecting to power.
Dual Power Type
(AC 24V/DC 12V, AC 24V Class2)
DC Power Type (DC 12V, 500mA)
15
Monitor
OSD EXTRA
IRIS JACK
VIDEO OUT
POWER
POWER
DC
SET
AC 24V IN VIDEO
AC 24V IN
DC12V IN
DC12V IN
OSD EXTRA
IRIS JACK
VIDEO OUT
POWER
POWER
DC
SET
AC 24V IN VIDEO
AC 24V IN
DC12V IN
DC12V IN
PIXIM Digital Day/Night Bodied Camera