Table of Contents
Advertisement
¡á Overview
External Control Connector
¨ê
Zoom and focus functions can be controlled using external siganals.
Power LED
¨ë
Illuminates when power is supplied.
Video Output Jack
¨ì
Used to connect an external video monitor in jack.
D/N Input Port (Short : BW, Open : Colour)
¨í
Switch to Day or Night Mode by connecting an external signal to this port.
(In case of DAY/NIGHT mode setted to EXT.)
Key Extra Connector
¨î
Connects to the remote controller(option) when you want to install remotely.
Power Input Terminal
¨ï
Power supply terminal (DC 12V, AC 24V).
¡á Connection
Connecting to Monitor
Connect Video Out Jack to the monitor's Video In jack as shown below.
CCD Camera
¤ýConnection methods may vary depending on the video equipment.
Please refer to the model specific instruction manual.
¤ýConnect cables with the unit powered down.
High Sensitivity Day&Night Power Zoom Camera
Monitor
12
¤ýSet the 75¥Ø/ Hi-Z selection switch as shown below if you have an
intermediate device.
CCD Camera
Intermediate
Connecting to Power
Each model has a different power input specification.
Please check the model type and standard power requirement before
connecting to power.
DC Power Type (DC 12V, 500mA)
Use DC 12V/500mA power source for
DC12V Only Model.
Power Input Terminal
AC/DC Power Type
Use AC24V/500mA or DC 12V/500mA
powersource for Dual Power Model.
Note
• Connect the power once the installation is complete.
• The wire is polarized. Match '+' and '-' terminals properly.
13
High Sensitivity Day&Night Power Zoom Camera
Connection ¡á
End monitor
Advertisement
Table of Contents
