Installation; Lens - Genie DN83SPX/12 Instruction Manual

■ Installation

■ Lens

Lenses are sold separately. Lenses such as auto iris lens,
CS-Mount lens and C-Mount lens can be used.
Note
ㆍUse of the DC auto iris lens is recommended to achieve the best
results for operating this product effectively.
ㆍKeep the lens clean.
ㆍAny foreign objects and fingermarks on the lens can cause inferior
image quality in low light level conditions.
When using an auto iris lens
1. Peel off about 8mm of the outer skin of the auto iris lens cable.
2. Peel off about 2mm of the outer skin of the insulated conductor inside
the lens cable.
PIXIM Digital Day/Night Bodied Camera
12
3. Remove the cover of the auto iris lens connection plug and solder the
lens cable to the connector pin in the plug.
Pin No.
DC
No.1 Pin Damping-
No.2 Pin Damping+
No.3 Pin Drive+
No.4 Pin Dreve-
4. Replace the auto iris lens connection plug cover and take off the lens
protection cap, and then attach the auto iris lens to the camera by screwing
it in clockwise.
5. Insert the connection plug that is connected to the auto iris lens cable into
the auto lens connector, which is located on the back of the camera.
6. Set the lens selection switch, located on
the back of the camera, to DC or VIDEO
depending on the type of auto iris lens
which is being used.
Installation ■
LENS
VIDEO
Red (power)
NC
White (video signal)
Black (GND)
IRIS JACK OSD EXTRA
VIDEO OUT
POWER
DC
SET
AC24V IN VIDEO
DC12V IN
13
PIXIM Digital Day/Night Bodied Camera