Connection Instructions - Atlona Omega AT-OME-MS42 User Manual

1. Connect a high-quality USB-C cable from a source to the USB-C (1) port.
2. Connect a DisplayPort cable from a source to the DP IN (2) port.
3. Connect up to two UHD/HD sources, using HDMI cables, to the HDMI IN (3) and HDMI IN (4) ports.
4. Connect an HDMI cable from the HDMI OUT port to a UHD/HD display.
5. Connect a category cable (CAT-5e or better) from the HDBaseT OUT port to a compatible receiver.
Refer to the tables below for recommended cabling when using Altona products with HDBaseT technology.
The green bars indicate the signal quality when using each type of cable. Higher-quality signals are represented
by more bars. These tables are for guidance, only. Performance may vary, based on environmental factors.
Core Shielding
Solid UTP (unshielded)
STP (shielded)
Cable
CAT5e
CAT6a / CAT6a / CAT7
PWR
LINK
IMPORTANT: Stranded or patch cable is not recommended due to performance issues.
OMEGA MULTI-FOMAT SWITCHER
TM
Sheilded cables are strongly recommended to minimize signal noise and interference.
IP MODE
RESET 1 USB HOST
1 2
USB-C IN DP IN
6. Connect up to two USB host devices to the USB HOST ports. Refer to
example application.
7. Connect USB devices to the USB HUB ports. Refer to Refer to
application for an example application.
8. Connect an Ethernet cable from the LAN port to the Local Area Network (LAN).
9. OPTIONAL: Connect the included 5-pin captive screw connector to the AUDIO OUT connector.
10. OPTIONAL: Connect the included 3-pin captive screw block to the RS-232 port. Refer to
Configuration Guide (page 65)
11. Connect the included power supply to the DC 24V connector and connect the power cord to an available
electrical outlet.
AT-OME-MS42

Connection Instructions

CAT5e
Max. Distance @ 4K
295 feet (90 meters)
330 feet (100 meters)
USB HUB
2
3 4
HDMI IN
for information.
CAT6 CAT6a
Max. Distance @ 1080p
USB-C USB-C
330 feet (100 meters)
DP
330 feet (100 meters)
HDMI 3 HDMI 3
HDMI 4 HDMI 4
HDMI OUT
HDMI OUT HDBaseT OUT
Connection Diagram (page 14)
Connection Diagram (page 14)
Installation
CAT7
N/A
AT-OME-MS42
DP
HDBaseT OUT
RS-232
AUDIO OUT
+ +
RX TX
L R
LAN DC 24V
for an
for an example
Solution Setup and
13