Ecom Instruments MCAL 4200 Instruction Manual page 77

OUT?
PRES?
PRESJJNIT?
PULSE_CNT
PULSE_CNT?
REMOTE
RTD_TYPE
RTD_TYPE?
RTD_WIRE
RTD_WIRE?
SIM
SIM?
TC_TYPE
TC_TYPE?
TEMPJJNIT
TEMP_UNIT?
TRIG
TRIG?
TSENS_TYPE
TSENS_TYPE?
UPPER_MEAS
U_PRES_UNIT
VAL?
ZERO_MEAS
ZERO_MEAS
Units
MA
mV
V
CPM
Hz
kHz
76
Returns the output of the calibrator
Returns the model and serial number of the attached pressure module
Returns the pressure unit for the upper and lower display
Sets the number of pulses for the pulse train
Returns the number of pulses in the pulse train
Puts the calibrator in remote mode
Sets the RTD type
Returns the RTD type
Sets the number of wires used by the RTD mode
Returns the wire number setting used in the RTD mode
Sets the output for mA simulation
Returns the output of the mA simulation
Sets the thermocouple type
Returns the thermocouple type
Sets input / output temperature unit for RTD and TC
Returns the temperature unit for RTD and TC
Starts and stops the pulse train in pulse mode
Returns TRIGGERED when a pulse train is on. Returns UNTRIGGERED
when the pulse train is off
Sets temperature sensor type.
Returns temperature sensor type
Sets the measuring mode for the upper display.
Sets the upper pressure unit
Returns the measured values
Zeros the pressure module
Returns the zero offset of the pressure module
Table 7: Parameter units
Meaning
milliamps of current
Voltage in millivolts
Voltage in volts
Frequency in cycles per minute
Frequency in Hertz
Frequency in kiloHertz