Table of Contents
Advertisement
Quick Links
Wireless DALI control unit, 1-gang Mini
Wireless DALI control unit, 1-gang Mini
Order no.: 5422 00
Operating instructions
1
Safety instructions
Electrical devices may only be mounted and connected by electrically skilled persons.
Serious injuries, fire or property damage possible. Please read and follow manual fully.
Danger of electric shock. Always disconnect before carrying out work on the device or load. In
so doing, take all the circuit breakers into account, which support dangerous voltages to the
device and or load.
Danger of electric shock. Device is not suitable for disconnection from supply voltage.
These instructions are an integral part of the product, and must remain with the end customer.
Further information about this device can be found in the operation manual on our web-
site.
2
Device components
(1)
Operating mode switch
Button Prog
(2)
(3)
Status LED
(4)
Measuring points for voltage measurement, terminals rear-mounted
3
Intended use
–
Switching and brightness setting of DALI luminaires
–
Operation with suitable radio transmitters
–
Mounting in appliance box according to DIN 49073 in combination with a suitable cover
–
Installation in surface-mounted housing or panel-mounted housing (accessories) for sus-
pended ceilings
Product characteristics
–
Joint operation of all the connected DALI ballasts, broadcast.
32580922
10864978
Figure 1: Front view
22.08.2019
1 / 14
Advertisement
Table of Contents
Related Manuals for Gira DALI 5422 00
Summary of Contents for Gira DALI 5422 00
- Page 1 Wireless DALI control unit, 1-gang Mini Wireless DALI control unit, 1-gang Mini Order no.: 5422 00 Operating instructions Safety instructions Electrical devices may only be mounted and connected by electrically skilled persons. Serious injuries, fire or property damage possible. Please read and follow manual fully. Danger of electric shock.
- Page 2 Wireless DALI control unit, 1-gang Mini – Electronic short-circuit protection of the DALI supply with permanent switch-off after 8 seconds – Electronic over-temperature protection of the DALI supply with self-retain – DALI supply for a maximum of 12 subscribers – Parallel switching of up to 6 DALI control units with the option of supplying up to 72 DALI subscribers –...
-
Page 3: Operation
Wireless DALI control unit, 1-gang Mini – Switch-off warning – Operation locks – Continuous on, Continuous off – Hotel function – Run-on time – Light control When operating with the eNet Server, operation and signalling could vary from what is de- scribed here. - Page 4 Wireless DALI control unit, 1-gang Mini Figure 2: Connection example The connected DALI subscribers may be operated on different phase conductors. The control cable and load cable can be run in a shared cable, e.g. NYM J 5×1.5. Ensure that the control cable with regards type, cross-section and routing complies with the VDE specifications for 250 V cables, DALI interface has basic insulation.
- Page 5 Wireless DALI control unit, 1-gang Mini ￭ Perform commissioning. ￭ Mount the cover. 5.2 Commissioning The control unit can also be commissioned with eNet server as an alternative to the com- missioning described here. Connecting to radio transmitters If several control units are switched in parallel, all radio transmitters will only connect to one control unit.
-
Page 6: Technical Data
Wireless DALI control unit, 1-gang Mini ￭ Switch on light. ￭ Turn operating mode switch (1) to the min. position. The light switches to maximum brightness for approx. 2 seconds. The light switches off and after approx. 2 seconds switches to the brightness that was last set. -
Page 7: Parameter List
Wireless DALI control unit, 1-gang Mini Parameter list The device parameters can be changed with the eNet server: Device and channels Parameters Setting options, Basic setting Explanations Function Light, unused Light Basic setting: Light The channel is integrated for the "Lighting" central function in the eNet SMART HOME app. - Page 8 Wireless DALI control unit, 1-gang Mini Parameters Setting options, Basic setting Explanations ness, then the system will switch to the appropriate limit value. Minimum brightness 1...67 % Specifies the minimum set- Basic setting: 5 % table brightness. Note: If parameters or scene values are set to a level lower than the minimum brightness, then the system will dim to...
- Page 9 Wireless DALI control unit, 1-gang Mini Parameters Setting options, Basic setting Explanations If scenes are recalled or switching uses logic modules, the switch-on brightness is ap- proached using so-called soft dimming (not configurable). Dim down ramp 0 s … 24 h Time until reaching minimum Basic setting: 0 s brightness.
- Page 10 Wireless DALI control unit, 1-gang Mini Parameters Setting options, Basic setting Explanations reset the counter to "0". The device must be programmed to apply the change. Extended channel settings Parameters Setting options, Basic setting Explanations Operating mode Normal operation see Device and channels Continuous on Continuous off Basic setting: Normal Opera-...
- Page 11 Wireless DALI control unit, 1-gang Mini Parameters Setting options, Basic setting Explanations the dim down ramp is applied. If, during the dim down opera- tion, another command is given, e.g. switch on or scene recall, then the switch-off warning stops and the com- mand is executed.
- Page 12 Wireless DALI control unit, 1-gang Mini Parameters Setting options, Basic setting Explanations Priority, sun protection 0...4 Specifies the priority for recall- Basic setting: 0 ing and removing a scene of type Sun protection for the channel. Activate sun protection bright- 0…100 % Defines the behaviour of the ness value...
-
Page 13: Troubleshooting
Wireless DALI control unit, 1-gang Mini Parameters Setting options, Basic setting Explanations off is only possible with a forced position command. Note: If the minimum bright- ness is set to greater than 20 %, then the system dims to the set minimum brightness when the hotel function is ac- tivated. -
Page 14: Warranty
Wireless DALI control unit, 1-gang Mini 10 Conformity Hereby Gira Giersiepen GmbH & Co. KG declares that the radio system type Order no. 5422 00 corresponds to the directive 2014/53/EU. You can find the full article number on the device. The complete text of the EU Declaration of Conformity is available under the Internet address: www.gira.de/konformitaet...