Technical Data - Gira DALI 5422 00 Operating Instructions Manual

Wireless DALI control unit, 1-gang Mini
￭ Switch on light.
￭ Turn operating mode switch (1) to the min. position.
The light switches to maximum brightness for approx. 2 seconds.
The light switches off and after approx. 2 seconds switches to the brightness that was last
set.
￭ Adjust brightness with the radio transmitter.
￭ Turn operating mode switch to the original position again.
When leaving the position min., the minimum brightness is saved. As confirmation, the
light switches to maximum brightness and switches to the set minimum brightness after
approx. 2 seconds.
Depending on the DALI ballast used, the signalling may vary from what is described here.
Save switch-on brightness
￭ Switch on light.
￭ Adjust brightness with the radio transmitter.
Press button Prog (2) for longer than 4 seconds.
￭
The light switches off briefly and then switches on again to the new switch-on brightness.
Switch-on brightness is saved.
Alternatively, the switch-on brightness can be saved with a radio transmitter, e.g. wall
transmitter.
6

Technical data

Rated voltage
Mains frequency
Power consumption
Ambient temperature
Rated voltage DALI
Output current
Number of DALI subscribers
Number of parallel control units
Power reduction
Number of DALI subscribers over 45 °C
Connection
single stranded
Finely stranded with conductor sleeve
Dimensions Ø×H
Radio frequency
Transmission capacity
Transmitting range in free field
Receiver category
32580922 10864978 22.08.2019
AC 230 V~
50 / 60 Hz
max. 2 W
-25 ... +70 °C
DC 16 V (typ.)
max. 24 mA
max. 12
max. 6
max. 8
0.75 ... 4 mm²
0.75 ... 2.5 mm²
53×28 mm
868.0 ... 868.6 MHz
max. 20 mW
typ. 100 m
2
6 / 14