Table of Contents
Advertisement
Wireless DALI control unit, 1-gang Mini
Parameters
Minimum brightness
Maximum brightness
Dimming adjustment time
Switch-on delay
Switch-off delay
Dim up ramp
32580922
10864978
Setting options, Basic setting
1...67 %
Basic setting: 5 %
75...100 %
Basic setting: 100 %
1...60 s
Basic setting: 4 s
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
22.08.2019
Explanations
ness, then the system will
switch to the appropriate limit
value.
Specifies the minimum set-
table brightness.
Note: If parameters or scene
values are set to a level lower
than the minimum brightness,
then the system will dim to
minimum brightness.
Specifies the maximum set-
table brightness.
Note: If parameters or scene
values are set to a level higher
than the maximum brightness,
then the system will dim to
maximum brightness.
Time from minimum bright-
ness until reaching maximum
brightness (dimming speed).
The load switches on after a
delay. Repeated switch-on
commands restart the delay
time. If the load has not yet
been switched on due to the
delay when a switch-off com-
mand comes, then the load
will remain off.
Note: The set time apply to
operation using radio transmit-
ters. The device is switched
immediately when the Prog
button is pressed.
The load switches off after a
delay. Repeated switch-off
commands restart the delay
time. If the load has not yet
been switched off due to the
delay when a switch-on com-
mand comes, then the load
will remain on.
Note: The set time apply to
operation using radio transmit-
ters. The device is switched
immediately when the Prog
button is pressed.
Time between switch-on and
reaching switch-on brightness.
The light is switched on at
minimum brightness and then
dimmed to the switch-on
brightness.
Only applies to switch-on with
transmitters (short operation).
8 / 14
Advertisement
Table of Contents
