Use; Temperature Setting; Using As A Steam Iron; Using As A Dry Iron - Black & Decker X750 Instruction Manual

English
Warning! Never fill above the maximum
filling level (9). Normal tap water can be
used, but if you live in a hard water area the
use of distilled water is recommended.
• Do not use chemically descaled water.

Use

Warning! Do not leave the appliance
unattended while it is connected to the
power supply and during the cool down
period.

Temperature setting

The required temperature setting depends
on the garment fabric.
• Adjust the temperature control dial (4) to
the required setting:
1 Silk / Nylon
2 Acctate / Acrylic
3 Polyester / Rayan
4 Cotton / Blends
5 Wool
6 Cotton
7 Linen
• If you are unsure of the fibre content of
a garment, start with a low temperature
setting and test on a small area (seam
or inside hem). If wrinkles remain,
gradually increase the heat setting until
you find the optimum setting.

Using as a dry iron

• Stand the appliance on its heel rest (6).
• Plug the appliance in and switch on.
• Set the steam control dial (2) to the 'O'
position.
• Adjust the temperature control dial (4) to
the required setting.
The heating light (5) will switch off when the
appliance has reached the required
temperature.

Using as a steam iron

• Fill the water tank as described above.
• Stand the appliance on its heel rest (6).
• Plug the appliance in and switch on.
• Adjust the temperature control dial (4) to
the required steam setting.
The heating light (5) will switch on. When
the heating light switches off, the iron will
be ready for use as a steam iron. The
heating light will regularly switch on and off
whilst ironing.
• To create steam, set the steam control
dial (2) to the required steam position.
Using the steam burst button
The steam burst feature can only be used
whilst ironing on a high temperature setting.
• Make sure that there is water in the tank
and the temperature control dial (4) is
set to the steam position.
• Lift the appliance and press the steam
burst button (3). You may need to press
a few times to activate the pump.
-6-