Temperature Setting - Black & Decker X2150 Manual

Steam Shot
Spray
Self Clean
Auto Shut Off
Features
1. Soleplate
2. Skirt
3. Spray nozzle
4. Handle
5. Water inlet cover
6. Handle cover
7. Steam control
8. Steam indicator
9. Spray button
10. Steam burst button
11. Auto shut off lamp
12. Cord protector
13. Heating lamp
14. Heel
15. Temperature control dial
16. Self clean button
17. Water tank
18. Filling jug
Before first use Cleaning the soleplate
In order to be able to use the steam function, you will first
need to fill the water tank (17) with water.
• Make sure that the appliance is unplugged.
• Fill the appliance with water as described below.
• Use the self-clean system as described below. When
finished, disconnect the appliance from the mains supply
and allow the unit to fully cool then wipe the soleplate (1)
and steam vents with a cloth.
Some parts of the appliance may have been lightly greased
and as a result the appliance may smoke slightly when
switched on for the first time. This will cease after a short
while.
(Original instructions)
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
Filling the water tank
In order to be able to use the steam function, you will first
need to fill the water tank (17) with water
• Unplug the Iron and take it to a water outlet
• Lift the water inlet cover (5).
• Hold the appliance at an angle.
• Fill the appliance with water to the required amount via
water outlet, or using the filling jug (18).
• Close the water inlet cover (5).
Warning! Never fill above the maximum filling level indicated
on the appliance. Normal tap water can be used, but if you
live in a hard water area the use of distilled water is
recommended. Do not use chemically de-scaled water.
Use
Warning! Do not leave the appliance unattended while it is
connected to the power supply and during the cool down
period

Temperature setting

The required temperature setting depends on the garment
fabric.
If you are unsure of the fibre content of a garment: start with
a low temperature setting and test on a small area (seam or
inside hem). If wrinkles remain, gradually increase the heat
setting until you find the optimum setting.
Using as a dry iron
• Stand the appliance on its heel rest.
• Plug the appliance in and switch on.
• Set the steam control (7) to the no steam position.
• Adjust the temperature setting dial (15) to the required
setting. The lamp (13) will switch off when the appliance
has reached the required temperature.
Using as a steam iron
• Fill the water tank as described above.
• Stand the appliance on its heel rest.
• Adjust the temperature control dial (15) to the required
steam setting.
The lamp (13) will switch on. When the heating light switches
off, the iron will be ready for use as a steam iron.
The heating light will regularly switch on and off whilst ironing.
• To create steam, set the steam control (7) and the steam
control dial (15) to the steam position.
• Plug the appliance in and switch on.
ENGLISH
5