Temperature Setting; Using The Steam Burst Button; Using The Spray Button - Black & Decker X750R Manual

ENGLISH

Temperature setting

The required temperature setting depends on
the garment fabric.
• Adjust the temperature control dial (4) to the
required setting:
1 Silk / Nylon
2 Acctate / Acrylic
3 Polyester / Rayan
4 Cotton / Blends
5 Wool
6 Cotton
7 Linen
• If you are unsure of the fibre content of a
garment, start with a low temperature setting
and test on a small area (seam or inside
hem). If wrinkles remain, gradually increase
the heat setting until you find the optimum
setting.
Using as a dry iron
• Stand the appliance on its heel rest (6).
• Plug the appliance in and switch on.
• Set the steam control dial (2) to the 'O'
position.
• Adjust the temperature control dial (4) to the
required setting.
The heating light (5) will switch off when the
appliance has reached the required
temperature.
6
Using as a steam iron
• Fill the water tank as described above.
• Stand the appliance on its heel rest (6).
• Plug the appliance in and switch on.
• Adjust the temperature control dial (4) to the
required steam setting.
The heating light (5) will switch on. When the
heating light switches off, the iron will be ready
for use as a steam iron. The heating light will
regularly switch on and off whilst ironing.
• To create steam, set the steam control dial
(2) to the required steam position.

Using the steam burst button

The steam burst feature can only be used whilst
ironing on a high temperature setting.
• Make sure that there is water in the tank and
the temperature control dial (4) is set to the
steam position.
• Lift the appliance and press the steam burst
button (3). You may need to press a few
times to activate the pump.

Using the spray button

The spray feature can be used at any
temperature setting when either steam or dry
ironing.
• Make sure that there is water in the tank.
• Press the button (1) several times to activate
the pump while you are ironing.