Microsemi Actel IGLOO Icicle Quick Start Manual

1. How to Start the demo

1.1. Upon power up, the display will default to a random pattern.
1.2. To display the message associated with the default design
shipped with the Icicle Kit:
1.2.1. Push SW1 to reset the board
1.2.2. Then press SW5 to enable and initialize the display.
1.2.3. The message ACTEL IGLOO will be displayed.
1.2.4. If this message is not displayed or flickers badly, the board
may have a manufacturing test design installed. In this case,
simply reprogram the board with the STAPL file included on the
IGLOO Icicle Kit CD.
1.3. To cause display to scroll continuously:
1.3.1. Push SW5 a second time. Further presses of SW5 will have
no affect on the display.
1.4. Once the message is scrolling, pushing SW1 will reset the board
and freeze the message.
1.5. To re-initialize the display, push SW5 once and to re-activate
the scroll, push SW5 a second time.
1.6. If the Flash*Freeze mode is initiated while the display is active,
the display retains its current state. At this point, the FPGA is no
longer driving the display. Since the information has already been
written to the OLED assembly, the display will continue to show
the same message. Upon exiting the Flash*Freeze mode, the display
will also retain its current state and function as described above.
1.6.1. In Flash*Freeze, the Current Sense LED will turn on to
show Low Current Mode.
1.6.2. The LED counter design will stop and restart from the same
count when it comes out of F*F
IGLOO Icicle Kit
Quick Start Guide