Prerequisites; Hardware; Operating System; Software - Bosch KTS 5a Series Original Instructions Manual

en | 18 | KTS 560 / 590 (KTS 5a Series) | Device description
3.2

Prerequisites

3.2.1

Hardware

PC/laptop with at least two free USB interfaces.
3.2.2

Operating System

Operating System
Win XP (from SP3)/Win Vista/Win 7/
WIN 8/Win 10
3.2.3

Software

In order to operate the KTS module, the current ES-
I[tronic] 2.0 software must be installed and enabled on
the PC/laptop. This is subject to additional cost.
3.3

Scope of delivery

i
The scope of delivery depends on the product variant
ordered as well as the special accessories ordered,
and can deviate from the following list.
Designation
Diagnostic device KTS 560
Diagnostic device KTS 590
Bluetooth USB adapter
OBD connection cable, 1.5 m
USB connection cable 3 m
Power supply unit
Measurement cable blue/yellow
Measurement cable red/black (KTS 590)
Measuring clamp black
(1x on KTS 560, 2x on KTS 590)
Test prods
Test prods
Protective cap
Case
DVD1 ESI[tronic]
Diagnosis and technology
DVD ESI[tronic] 2.0
Mounting bracket with 3 oval-head screws
Important information and safety instructions
Instruction manuals
|
1 689 989 223 2016-12-15
!
Bosch PC with operating system Win 7, fitted ,e.g.,
in BEA 850/950, FSA 740 or FSA 760 in the trol-
ley have to use the USB 3.0 port for the Bluetooth
USB adapter. Exception: On the DCU 100 / 130 /
220, the internal Bluetooth hardware can be used.
If a different Bluetooth USB adapter is plugged in,
proper operation of the USB functionality cannot be
USB Bluetooth
guaranteed.
x x
!
Use measurement cables for measurements smaller
than 60 VDC, 30 VAC or 42 VACpeak only.
Order number
–
– !
The OBD connection cable (1 684 465 755) included
–
in the scope of delivery must only be connected to
1 684 465 755
KTS 560 / 590 and not to any other KTS modules.
1 684 465 562
1 687 023 736
1 684 463 950
1 684 463 945
1 681 354 035
1 683 050 050
1 684 480 125
1 680 591 037
1 685 438 648
1 987 729 601
1 987 P12 037
–
1 689 979 922
1 689 989 223
1 689 989 266
1 689 989 277
The accessories must only be used in circuits
which are not connected to a mains voltage
supply (measuring category 0 according to
EN 61010-2-030:2010). The enclosed accesso-
ries must only be used with Bosch products,
and at voltages below the voltage value as
imprinted on the accessories. When combin-
ing accessories, it must be ensured that the
lowest voltage value imprinted on the acces-
sories is not exceeded.
en
Robert Bosch GmbH