Advertisement
Before using for the first time
Assemble the appliance
1. Photo sequence D:
• Fit the wheel
11
onto the axle
• Fit the other wheel, ensuring that the pin
fits into the recess in the axle.
• Push the plugs
10
until they fit into place (as shown in the
cross-section drawing)
• Fit the tank
.
T
2. Photo sequence E:
Note: Turn the appliance around to face
the rear of the unit for the following sequence
of instructions.
• Securely mount the nozzle holder
(with the Phillips screw and washer) onto
the bottom right hand side of the unit,
fitting it onto the relative lug
• Securely attach the accessory holder
14
(with the rounded side facing down) at
the rear of the unit
• Fix the accessory support
winder
on the left and to the nozzle
9
holder on the right
3. Photo sequence F:
• Nozzle cleaning pin fixture
• Securely attach the hose reel support
5
to the rear of the unit, using 2 Phillips
screws. Ensure that the side with the round
and rectangular openings is installed on
the left hand side
• Completely unwind the hose from the hose
winder before assembling the 2 parts.
• Take the 2 sections of the hose reel
• Fit the 2 sections together and feed the
hose out through the aperture
• Now secure the 2 sections with 4 Phillips
screws
• The high-pressure hose end
attached to the gun.
4. Photo sequence G:
• Turn the drum
7
connector on the left hand side
• Fit the previously assembled drum
7
onto the bracket at the rear of the unit.
Press on the drum to secure it into its
8
into the wheel centres
15
(a)
14
to the cable
(b).
15
13
26
will be
, keeping the hose
Usage
mountings on the bracket.
• Fit the hose connector underneath and
screw securely onto the outlet connector
• Fit the crank handle
side of the drum
7
• Rewind the hose with the handle, without
tightening excessively.
• Connect the short high-pressure hose
connector to the spray gun quick release
connector. Lift the ring on the spray gun
mount
, insert the end of the hose
4
and release the ring. Check that it
26
has engaged correctly.
• Secure the handle
unit with 3 Phillips screws.
Usage
Caution: For safety reasons, always use
both hands to assemble the nozzle
spray gun
before starting a job.
4
Connection to the water mains
16
Main ON / OFF switch
17
High-pressure water outlet (OUTLET)
18
Plug/wall socket
19
Water tap
20
Water supply hose
21
Water inlet (INLET)
22
Water filter
23
Mounting
24
Snap-on hose connector
25
Detergent tank
26
High-pressure hose
27
Spray gun safety catch
28
Spray gun trigger
• Check that the main switch
• The water inlet hose
the snap-on hose connector
Caution: use a hose with a minimum
pressure resistance of 15 bar / 200 psi,
and an internal diameter of at least 13
6
to the right hand
with a Phillips screw
to the rear of the
12
and
3
16
is "OFF";
must be fitted to
20
24
GB
5
Advertisement
