Advertisement
Troubleshooting
Repair
Fault
Cause
Repair
GB
Fault
10
Cause
Repair
• Remove and clean the
filter (see paragraph
"MAINTENANCE /
CLEANING").
• Use water at a
temperature lower than
40°C.
• Contact your
authorised customer
service centre.
Water contaminated
with oil.
• O-ring seals worn.
• Contact your
authorised customer
service centre.
The machine restarts
with the gun released.
• Water leak from hose-
gun connection
(except models with
hose and gun supplied
ready-connected).
• Air in intake water.
• Water leak from the
gun.
• Water leak from the
pump.
• Tighten the connection
ahead of the quick
release connector
using 2 suitable
spanners.
• Connect the machine
to a suitable water
supply.
• Contact your
authorised customer
service centre.
Fault
The machine does not
suck in detergent.
Cause
• Tank empty.
• Nozzle regulator knob
turned to "+".
• The transparent pick-
up tube inside the
appliance is damaged
or disconnected.
• The drain hole of the
tank is plugged.
Repair
• Fill the tank.
• Turn the regulator
knob to the low-
pressure setting.
• Contact your
authorised customer
service centre.
Advertisement
