Advertisement
Safety
Before using for the first time
an electrical overload cutout system (CL.
I) and pump bypass valve or stop system.
•
CAUTION: The spray gun is
equipped with a safety catch.
When the appliance is not in use,
always engage the safety catch
to prevent the machine from being started
unintentionally.
• Never direct the jet towards yourself or
any other person to clean clothing or
footwear.
• Never allow children or persons without
the necessary skills to operate the
machine.
• CAUTION: Do not leave the appliance in
standby mode for more than 5 minutes.
• CAUTION: Always switch off the appliance
completely (main switch OFF) whenever
leaving it unattended.
• CAUTION: This machine uses high-
pressure fluids. Always grip the gun
firmly to counteract the recoil. Only use
GB
the high-pressure nozzle supplied with the
machine.
4
Additional safety information
Water supply
• See chapter "Technical specifications".
• Only use clean water.
Caution: Failure to observe the above
conditions will cause serious mechanical
damage to the pump and will void the
guarantee.
High-pressure hose
Caution: The high-pressure hose
26
has been specially designed to resist
high pressures. Treat with particular care
to prevent damaging it.
• Avoid tangling.
• Do not bend the hose or subject it to high
stress or strain
• Never start the high-pressure cleaner
without first completely unwinding the high-
pressure hose
26
.
• Before unwinding or winding the hose,
switch the machine off and release the
pressure in the hose itself (pull spray
gun trigger
Caution: Inappropriate use may cause
damage or untimely breakage and voids
the guarantee.
Electrical power supply
• Warning: Before connecting the appliance,
ensure that the specifications listed on the
identification plate match those of the mains
electric supply and that the socket
protected by a differential magneto-thermal
circuit breaker with a trip threshold less
than 0.03A - 30ms.
• If the mains power lead or plug is damaged,
have it repaired or replaced by a customer
service centre.
4
• Do not use the appliance at temperatures
lower than 0°C.
Caution: Non-approved extension leads
may be dangerous and must never be
used.
• If an extension lead is used, both the plug
and the socket must be waterproof and the
cable cross section must be as specified
in the following table.
230 - 240V
1,5 mm
2,5 mm
Before using for the first time
Warning:
• Before assembly, ensure that all
appliances and accessories listed in the
chapter "Equipment" are present
• Each unit is test run after manufacture,
therefore you may find some residual water
in the water intake.
2-3 times).
4
2
max 20 m
2
max 30 m
18
is
Advertisement
