Setting The End Point - Tascam DP-004 Owner's Manual

processed further or combined with other recordings
(see "Exporting a stereo master" on page 100).
NOTE
Only one stereo master can be made in a song at a time.

Setting the end point

Before you start mastering, set the mastering end
point. The time between the song's zero point (00:
00: 00: 00) and the OUT point will be recorded as
the stereo master. Ordinarily, the end point of the
song is set as the OUT point. In this case, the time
at the OUT point is the length of the song. Use the
following procedures to set the OUT (end) point.
1 Press the key to open the
IN/OUT
screen.
2 Play the song back, and press the
I /O SETTING
TIP
You can also set the OUT point when playback is
stopped by pressing the F4 (OUT) key.
3 Press the
NOTE
For how to adjust the OUT point and for other functions,
see "Setting IN and OUT points" on page 73.
6–Basic Recording
the position where you want the stereo master end
point. " " appears and this position is set as
SET OUT !
the OUT point.
key to return to the Home Screen.
HOME
key at
F4 ( )
OUT
63
TASCAM DP-004