Table of Contents
Advertisement
5 − Mixer
Stereo dynamics
The stereo bus has a stereo dynamics processor (compres-
sor or expander) available.
1
With the
SHIFT
indicator lit, press the
The STEREO DYNAMICS screen appears.
Stereo fader
Press the
STEREO
key to open the screen below.
As with the channel fader screen, the on-screen fader can-
not be used to make adjustments. Also note that the inter-
nal fader value and the top panel physical fader position
may not correspond (see " Faders " on page 32).
34
TASCAM 2488neo
2
Press the
LIBRARY screen appears.
SELECT
key.
3
Use the
(
PRESET
The
settings, while
custom settings.
4
Use the dial to select library entries
5
Press
The STEREO DYNAMICS screen reappears, and
the selected preset parameters appear.
6
Use the cursor keys and dial to select and adjust the
parameters for the effect. Note that the last param-
eter is an on/off switch. When set to off, the dynam-
ics processor is bypassed.
NOTE
The stereo dynamics and mastering compressor (see
page 71) are not compatible.
In this case, the
level, and
marked by the triangular symbol beside the on-screen fader).
In both cases, 0 is full cut, 127 is full up, and 100 is the
unity gain value.
YES/ENTER
key. The DYNAMICS
/
cursor keys to select preset setting
Ó
Á
) or the user setting (
USER
PRESET
category contains factory preset
USER
can be used to save and recall
YES/ENTER
to load the entry.
LVL
value corresponds to the physical fader
INT
gives the internal virtual fader value (as
).
Advertisement
Table of Contents
