Table of Contents
Advertisement
7 − Recorder
Editing the active mark
This process is sometimes referred to as trimming. This
is a similar process to the jog positioning of the playback
point (see "Jog positioning" on page 48), except that in this
operation, the final position is stored as the position of the
active mark.
You can edit the active mark when playback is stopped.
You cannot edit the active mark when recording or
playing back.
1
Make sure that the mark you want to edit is shown
on the home display and that playback is stopped.
2
Press the
TRIM
key. The display shows TRIM and a
view of the waveform of the currently selected track
at the active mark.
3
Press the
SELECT
key of the track that you want
to view. The display changes to the waveform of
that track.
Although the active mark applies to all tracks,
if you have a track selected with nothing or little
recorded on it at that point, it will be impossible to
see or hear anything using this function.
4
Use the
and
keys to zoom out and in respec-
Ó
Á
tively horizontally. That is, pressing the
increase the amount of space on the screen taken by
a certain amount of time, and pressing the
will make the same amount of time take less space
on the screen. The three zoom levels available are:
x 1, x 2 at about single-frame accuracy), and x 32 at
about 10-sub-frame accuracy (shown below the time
display).
Skip between marks
During playback or when the transport is stopped, press
the
or
key briefly and release it to skip to the
F FWD
REW
next or previous mark.
52
TASCAM 2488neo
5
Use the
(the way that the volume of the sound is shown).
The zoom levels here are x 1, x 2, x 4, x 8, x 16
and x 32. Pressing the
cal scaling of the display, and pressing the
decreases the scale.
NOTE
If you cannot see any waveforms when you first enter
this display, press the § key to zoom the volume so
that you can see the quiet passages.
6
Use the
tion as you like. You can monitor the jogged sound
of the selected track through the monitoring system.
NOTE
You cannot move the mark to a position before the
previous mark or after the next mark.
7
To move past the edge of the screen, press and
hold the
forwards or backwards at normal speed for a rough
position. When you release the keys, the playback
will stop.
8
Press
active mark value (the playback position is now the
new position), and return to the home screen.
9
Press
the playback position being the point which has just
been set, but the active mark value is unchanged.
key will
Á
key
Ó
and
keys to adjust the vertical scale
§
¶
key increases the verti-
JOG/DATA
dial to move the playback posi-
and
keys to play the tracks
F FWD
REW
YES/ENTER
to accept the new position as the
NO/EXIT
to return to the home screen with
key
¶
Advertisement
Table of Contents
