Soloing And Toggle; Scene Memories; Scene Recall; Internal Faders And Physical Faders - Tascam 2488neo Owner's Manual

Soloing and toggle

If you press the SOLO key to the upper right of the
fader, the indicator lights and solo mode acti-
STEREO
vates. In solo mode, the track channel
function as SOLO keys, allowing you to monitor just the
track channel signals of your choice.
The MUTE/SOLO keys of any soloed channels flash while
being soloed.

Scene memories

The 2488neo can store and recall up to 100 scene memo-
ries. Each memory stores all the digital parameters for:
Input assignment
•
EQ settings
•
• Effect settings and assignment (assignment and param-
eters for both internal effects units)
Effect send and loop levels
•
Pan-pots
•

Scene recall

Follow these procedures to recall a scene.
1 Press the SCENE key to open the SCENE
LIBRARY screen.
2 Use the cursor key to select
˙
3 Select the scene that you want to recall.
4 Press the key to recall the scene.
YES/ENTER

Internal faders and physical faders

ª
If the fader matching mode (described below) is changed
from the factory setting, when a scene is recalled, the
MUTE/SOLO keys
LOAD .
Muted channels cannot be soloed or unmuted while solo
mode is active.
When soloing channels, the solo is "in-place.," mean-
ing that faders, pan controls, EQ, etc. affect the soloed
sound, and channels other than those with their
pressed are muted.
• Digital pad/gain
• Fader settings (including the
• Sub-mixer settings
NOTE
TRIM control, monitor, and mastering tool settings are
not stored as part of a scene.
recalled internal fader values and the physical fader posi-
tions may not match.* For this reason, audio levels may
change suddenly after recalling a scene. Remember to turn
down the output volume when recalling scenes to avoid
sudden changes in volume.
*In the factory fader matching setting, the internal fader
values always match physical fader positions.
NOTE
If the fader matching setting is changed from the
factory setting, the following cases may also cause
the internal fader values and physical fader values not
to match:
If a different song is recalled.
•
If external MIDI fader control is used.
•
• If a physical fader position is changed while the
unit's power is OFF.

Fader matching

ª
If the fader matching mode is not changed from its factory
settings, then the physical fader positions will always show
the actual fader levels (internal fader values) when you
use the 2488neo. In this setting, however, fader data is not
recalled with scenes.
5 − Mixer
keys
SOLO
STEREO fader)
37
TASCAM 2488neo