Operating Statuses, Signaling, Reactions; Table 19: Operating Statuses, Signaling, Reactions - WAGO EPSITRON 787-1668 Series Manual

34 Function Description
6.4

Operating Statuses, Signaling, Reactions

Table 19: Operating statuses, signaling, reactions

Status Operating status Channel LED
0 Device
initialization.
1 Output activated,
function OK.
2 Output current
greater than
nominal current.
3 Output de-
activated
manually, or by
control input S1.
4 Output de-
activated due to
excessive current.
Cooling (waiting)
period is active.
5 Output de-
activated due to
excessive current.
Cooling (waiting)
period is
completed.
6 Device error:
Defective fuse
detected.
1
The outputs are re-activated based on the load applied as soon as device initialization is
concluded.
2
The output is de-activated automatically in accordance with the given trip curve. The
device then switches to Status 4.
3
The status is saved when the device is switched off.
4
After a defined waiting period (cooling time), the output switches to Status 5. The
remaining time of the waiting period is saved when the device is switched off. This time
must first elapse when the device is switched on again. This feature protects the switching
elements against any overloading.
5
The output can be re-activated as follows:
• by pressing the associated button twice, or
•
The device then switches to Status 1.
off
1
on
on
2
off
3
off
4
off
5
off
by applying a pulse at control input S1.
787-1668 Electronic Circuit Breaker
Signal output
S3 (common
signal)
off 0 V
Green 24 V
Green 24 V
flashing
Red 24 V
Red 0 V
flashing
Orange 0 V
flashing
Red 0 V
flashing,
rapid
EPSITRON®
Button is Control input S1
 Transition
pressed
 Transition
to ...
to ...
-
Status 3 Status 3
(via bit pattern)
Status 3 Status 3
(via bit pattern)
Status 1 Status 1
(via bit pattern)
-
Status 3 Status 1
(using pulse
longer than 0.5 s)
Status 6
Version 1.1.0
-
-
-
Manual