Assa Abloy EMTEK EMTouch Classic Style Installation & Programming Manual page 11

Keypad Operation - Beeper & LED Indicators
Invalid Code/Access Denied*
Lock-Out Mode Error
Blackout Battery
Button Press Accepted
Outside Thumb Turn Enabled
* If 3 consecutive incorrect codes are entered, the lock emits 4 short beeps and a flashing Red EMTEK
button. The lock will not accept additional input for 20 seconds (20 beeps). When the next valid code is
entered the lock will beep quickly 5 times to alert of the incorrect codes.
** Battery voltage has dropped too low; keypad will be disabled but metal key override will still work.
Restoring the Lock to Factory Default Setting
This procedure clears the lock of all users and restores the Programming Code and
2 User Codes shipped with the lock.
• Press and hold EMTEK button for 3 seconds.
• Enter 000000
"
• After 2 beeps and 2 Green LED Flash, remove power (disconnect 9V battery)
from Lock.
• After 5 seconds, restore power (reconnect 9V battery)
• Confirm by 2 beeps and 2 Green LED Flash.
U.S. patent: 8,141,400
International patents pending.
IN8-EMTOUCHDB
Function
Valid Code
Access Accepted
Low Battery
**
"
Indicators
• 1 short beep, EMTEK button flashes
Green.
• 1 Red LED flash
• 2 short beeps
• 2 short beeps
• 1 short beep per second for duration
• 1 short beep
• 1 Green LED flash
• 4 Red LED flashes
• 4 short beeps
• 1 long Red LED flash
• 4 long beeps
• 1 Yellow LED flash
• 1 Short Beep
• 2 Green LED flashes
Place Sticker Here
06/24/2013
11