Table of Contents
Advertisement
Ethernet Speed
Auto
The codec will auto-detect the speed/duplex on the LAN.
10/Half
The codec will connect to the LAN using 10Mbps speed/Half Duplex.
10/Full
10 Mbps speed/Full Duplex.
100/Half
100 Mbps speed/Half Duplex.
100/Full
100 Mbps speed/Full Duplex.
Restart
Pressing the Quick key 'Restart' will restart your system without having to use the On/Off switch on the codec. If
IP-assignment is changed, it is sufficient to use this Quick key to restart the system.
SNMP Settings
SNMP Trap Host
SNMP (Simple Network Management Protocol) is used for monitoring and configuring of different units in a
network. The codec's SNMP Agent responds to requests from SNMP Managers (a PC program etc.). SNMP
traps are generated by the agent to inform the manager about important events.
SNMP Trap Host identifies the IP-address of the SNMP manager.
Traps can be sent to multiple SNMP Trap Hosts. Enter the IP address of up to three SNMP managers. All traps
will then be sent to the hosts listed.
SNMP Community
SNMP Community names are used to authenticate SNMP requests. SNMP requests must have a 'password' in
order to receive a response from the SNMP agent in the codec.
NOTE
T
SNMP C
HE
OMMUNITY NAME IS CASE SENSITIVE
TANDBERG Videoconferencing System
.
83
Advanced use
Advertisement
Table of Contents
