Table of Contents
Advertisement
Getting started
TANDBERG Videoconferencing System
Getting started
System start-up
Your system should be in standby mode. When in standby mode, pressing any key or picking up the remote
control will wake up the system. An incoming call will also wake up the system.
If the system does not respond, make sure the system is switched on by using the On/Off
switch located at the rear of the Codec (see figure below). After a few seconds you should
see the 'Welcome' menu on the monitor.
If this does not help, verify that your monitor is switched on.
Welcome menu
After a user-definable boot-up logo is shown, the following menu appears on the screen. This menu should provide
you with the most important system information. The three color-coded commands shown correspond with the
Quick keys on the remote control. This means that to make a call, you can press the green quick-key.
22
Advertisement
Table of Contents
Need help?
Do you have a question about the Video Conferencing System 7000 and is the answer not in the manual?