Verify Contents - HP NetServer LH 3 Installation Road Map

NetServer LH 3 Installation Road Map
Table of Contents

1. Verify Contents

2. Overview of NetServer Features
3. Obtain HP Navigator CD-ROM Release History
4. Connect Monitor, Keyboard, and Mouse
5. Preparation
6. Removing and Replacing the Covers
7. Install Additional Memory
8. Install All Accessory Boards
9. Install Additional Mass Storage Devices
10. Replace Covers and Cables
11. Verify Installed Accessories (Optional)
12. Configure the HP NetServer
Verify Contents
1
Unpack and verify the contents of the shipping box against the Contents Checklist included with your HP NetServer. If anything is missing or damaged,
contact your reseller.
2 Overview of NetServer Features
Front Panel
Display
Non-Hot-Swap Shelves:
Bezel Lock
Shelf 1 (Flexible Disk Drive)
Shelf 2 (CD-ROM Drive)
Shelf 3 (Empty)
Shelf 4 (Empty)
Hot-Swap
Mass Storage
Expansion
Bay (Empty)
Accessory Board
Sockets
Hot-Swap
Power Supply
Expansion Bay
(Empty)
Redundant Fan
Expansion Bay
(Empty)
All manuals and user guides at all-guides.com
Power Switch
Reset Switch
Keyboard Lock Switch
Status Lights
Display Control
Buttons
Hot-Swap
Mass Storage
Cage
Front View
Power redundancy requires three power
NOTE
supply modules. No redundancy is
available with two modules.
I/O Board
Left Front View
Audience Assumptions
This road map is intended for the person who installs, administers,
and troubleshoots LAN servers. Hewlett-Packard Company assumes
that you are qualified in the servicing of computer equipment and
trained in recognizing hazards in products with hazardous energy
levels.
ESD Warning
This HP NetServer contains sensitive electronic devices that can be
damaged by electrostatic discharge (ESD). ESD hazards are a result
of installation or service personnel failing to ground themselves
properly. To be properly grounded, use a proper ESD wrist strap and
work surface grounded to the HP NetServer chassis.
Tools Required
Installation of some accessories require a T15 TORX or a 1/4-inch
flat blade screwdriver, depending on the accessory.
I/O Connectors:
Remote Management
Serial B
Serial A
Parallel
Mouse
Keyboard
Monitor
Hot-Swap
Power Supply
Modules
AC Power
Connector
Rear View
System Board
Right Front View
®
Accessory Board
Slot Covers
Hot-Swap
Power Supply
Expansion
Bay (Empty)
Backplane
Hot-Swap
Power Supply
Cage