Verify Contents - HP NetServer LH 3r Installation Road Map

NetServer LH 3r Installation Road Map
Table of Contents

1. Verify Contents

2. Obtain Novell IntranetWare Key (Optional)
3. Overview of NetServer Features
4. Obtain HP Navigator CD-ROM Release History
5. Removing and Replacing the Covers
6. Install Additional Memory
7. Install All Accessory Boards
8. Replace Covers and Cables
9. Install the NetServer in the Rack
10. Install Additional Mass Storage Devices
11. Make External Connections
12. Configure the HP NetServer
Verify Contents
1
Unpack and verify the contents of the shipping box against the Contents Checklist included with your HP NetServer. If anything is missing or
damaged, contact your reseller.
2
Obtain Novell IntranetWare Key
Obtain IntranetWare software key (optional):
HP NetServer, purchase the software and obtain the key before beginning NOS installation in panel 12, "Configure the HP NetServer." Use the key
request form in the HP NetServer Software Option Package.
3 Overview of NetServer Features
Shelf 1 (Flexible Disk Drive)
Shelf 2 (CD-ROM Drive)
Shelf 3 (Empty)
Hot-Swap Mass
Shelf 4 (Empty)
Storage Expansion
Bay (Empty)
Hot-Swap Mass
Storage Cage
Front View
Accessory Board
Sockets
All manuals and user guides at all-guides.com
If you plan to install the optional Novell IntranetWare software that came with your
Power Switch
Reset Switch
Keyboard Lock Switch
Status Lights
Display Control
Buttons
Front Panel
Display
Power redundancy requires three
NOTE
power supply modules. No redundancy
is available with two modules.
I/O Board
Top View
Audience Assumptions
This road map is intended for the person who installs, administers,
and troubleshoots LAN servers. Hewlett-Packard Company assumes
that you are qualified in the servicing of computer equipment and
trained in recognizing hazards in products with hazardous energy
levels.
ESD Warning
This HP NetServer contains sensitive electronic devices that can be
damaged by electrostatic discharge (ESD). ESD hazards are a result
of installation or service personnel failing to ground themselves
properly. To be properly grounded, use a proper ESD wrist strap and
work surface grounded to the HP NetServer chassis.
Tools Required
Installation of some accessories require a T15 TORX or a 1/4-inch
flat blade screwdriver, depending on the accessory.
Accessory Board
Slot Covers
I/O Connectors:
Remote
Management
Serial B
Serial A
Parallel
Mouse
Hot-Swap Power
Keyboard
Supply Modules
Monitor
System Board
Bottom View
®
Hot-Swap Power Supply
Expansion Bay (Empty)
AC Power
Connector
Rear View
Hot-Swap
Power Supply
Cage
Backplane
Redundant Fan
Expansion Bay
(Empty)