Sony MPE-200 Installation Manual page 18

Multi image processor
Hide thumbs Also See for MPE-200:
Table of Contents

Advertisement

<LED >
Ref No.
Address
Name
D107
(A-2)
1
D108 to
(A-2)
2 to 5
111
*1:
State
INFORMATION LED
Warning state
Blinking (blue)
Error state
Blinking (red)
*2:
Error status display
When an abnormality is detected and error LED "1" inside the front panel lights (red) or blinks (red), four status LEDs
from "2" to "5" (D108 to D111/KY-660 board) lights as follows.
Error code
"1"
1
Light / Blink
2
Light / Blink
3
Light / Blink
4
Light / Blink
5
Light / Blink
6
Light / Blink
7
Light / Blink
8
Light / Blink
9
Light / Blink
A
Light / Blink
B
Light / Blink
C
Light / Blink
D
Light / Blink
E
Light / Blink
F
Light / Blink
* : With LEDs from "2" to "5",
indicates that the light is on, and
Note: When LED "1" is unlit (normal operation), all the LEDs from "2" to "5" light up. However, when the unit starts in the backup mode with dip switch (S102/
KY-660 board) No. 1 (S102-1) inside the front panel turned ON, all the LEDs from "2" to "5" blink while LED "1" stays unlit.
*3: The system control is the embedded CPU to start and shut down the system, and to monitor the state of the system.
1-10 (E)
Indication
Function
color
Red
Displays the status at the time when an error was detected
in combination with INFORMATION LED on the front panel.
Green
Displays the error status when D107 lights or blinks.
D107 "1"
Blinking (red)
Lit (red)
"2" to "5"
Possible cause
2 3 4 5
*
The hardware has a problem.
2 3 4 5
*
The hardware has a problem.
2 3 4 5
*
Not used
2 3 4 5
*
The fan has a problem.
2 3 4 5
*
The temperature has risen.
2 3 4 5
*
The power supply has a problem.
2 3 4 5
*
Action around the Cell/B.E. chip on the BE-28A board has a problem.
2 3 4 5
*
Action around the RSX chip on the BE-28A board has a problem.
2 3 4 5
*
Not used
2 3 4 5
*
Not used
2 3 4 5
*
Not used
2 3 4 5
*
Not used
2 3 4 5
*
The lithium battery on the BE-28A board has a problem.
2 3 4 5
*
The system control
2 3 4 5
*
The system control
indicates that the light is off.
*2
*3
has a problem.
*3
is operating in backup mode.
Normal state
Lights off
*1
Lights off
MPE-200

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MPE-200 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents