Items Supplied; Assemble Appliance; Operation; Start And Switch Off The Appliance - Silvercrest STV 45 D3 Operating Instructions Manual

__CPE282343_TowerVentilator_B4.book Seite 5 Mittwoch, 7. Dezember 2016 8:39 20
WARNING! Risk of material
damage
Never place the device on hot surfaces
(e.g. hob plates) or near heat sources or
open fire.
Only use the original accessories.
Do not use any astringent or abrasive
cleaning agents.

4. Items supplied

1 tower fan 1
1 base (consisting of 2 parts) 8
1 screw
1 set of operating instructions
Unpacking
1. Remove all parts from the packaging.
2. Check that all parts are present and in-
tact.

5. Assemble appliance

Before the device can be used, the base 8
must be screwed on:
1. Figure A: put the rear half of the
base 10 and the front half of the
base 11 together. Ensure that the con-
nection audibly clicks into place.
NOTES:
• The rear half of the base 10 can be
identified by the recess for the mains
power cable 9.
• Ensure that the mains power cable 12 is
lying in the recess for the mains power ca-
ble 9.
2. Figure B: place the tower fan 1 on
the base 8. Ensure that it is standing
safely, and that the mains power ca-
ble 12 is lying in the recess for the mains
power cable 9.
3. For safety reasons, screw the tower
fan 1 firmly onto the base 8. For this
purpose, use the screw supplied.
4. Select a location which complies with
the safety instructions (see "Safety infor-
mation" on page 3).
5. Insert the mains plug 12 into a mains
socket corresponding to the technical
data.

6. Operation

6.1 Start and switch off the
appliance
1. Plug the power plug into a power sup-
ply socket which meets the technical
data requirements.
2. Switch on the power
supply by turning rota-
ry switch 2 to ON.
The appliance is now
operational.
3. Switch off the power
supply by turning rota-
ry switch 2 to OFF.
5
GB