Silvercrest STV 45 D3 Operating Instructions Manual page 6

__CPE282343_TowerVentilator_B4.book Seite 4 Mittwoch, 7. Dezember 2016 8:39 20
If the mains power cable of this device should become damaged, it
must be replaced by the manufacturer, the manufacturer's customer
service department or a similarly qualified specialist, in order to
avoid any hazards.
This device is not intended to be operated using an external timer
clock or a separate remote control system.
DANGER for children
Packing materials are not children's
toys. Children should not be allowed to
play with the plastic bags: there is a risk
of suffocation!
Keep the device out of the reach of chil-
dren.
DANGER to and from pets
and livestock
Electrical devices can represent a haz-
ard to pets and livestock. In addition,
animals can also cause damage to the
device. For this reason you should keep
animals away from electrical devices at
all times.
DANGER! Risk of electric
shock due to moisture
The device, the cable and the mains
plug must not be immersed in water or
any other liquids.
Protect the device from moisture, water
drops and water spray. Failure to ob-
serve this instruction may result in an
electrical shock hazard.
If liquid gets into the device, remove the
mains plug immediately. Have the de-
vice checked before reusing.
Never touch the device with wet hands.
If the device has fallen into water, pull
out the mains plug immediately, and
only then remove the device from the
water. Do not use the device again, and
have it checked by a specialist.
4
GB
DANGER! Risk of electric
shock
Never put the device into operation if
there are visible damages to the device
or the power cable or if the device has
been dropped before.
Only connect the mains plug to a proper-
ly installed and easily accessible wall
socket whose voltage corresponds to the
specifications on the rating plate. The
wall socket must continue to be easily ac-
cessible after the device is plugged in.
Ensure that the power cable cannot be
damaged by sharp edges or hot surfac-
es.
When using the device, ensure that the
power cable cannot be trapped or
crushed.
The device is not fully disconnected from
the power supply, even after it is
switched off. In order to fully disconnect
it, pull out the mains plug.
When removing the mains plug from the
wall socket, always pull the plug and
never the cable.
Disconnect the mains plug from the wall
socket...
... if there is a fault,
... when you are not using the device,
... before you clean the device and
... during thunderstorms.
To avoid any risk, do not make modifi-
cations to the product.
Fully unwind the mains cable during use
to avoid overheating and scorching.
When using an extension cable, this
must correspond to the applicable safe-
ty regulations.